-
******** ISSI change using AT command
Hi!
There is setting in CPS to change ******** tetra radio ISSI using AT command. Anybody tried it? What AT command is that?
-
2024-03-02 04:49 PM
# ADS
Circuit advertisement
-
Re: ******** ISSI change using AT command
Got the answer.
AT+CNUMF=0,(ISSI)
It works.
-
Junior Member
Reputation: 9
Re: ******** ISSI change using AT command
Hello, the radio and computer are connected. Is it using a data cable or software to use a computer's super terminal?
-
Re: ******** ISSI change using AT command
Use usual hyperterminal, which can send AT commands through serial connection
-
Junior Member
Reputation: 9
Re: ******** ISSI change using AT command
Originally Posted by
es4tix
使用常用的超级终端,它可以通过串行连接发送 AT 命令
Ok, I'll test it, thanks.
-
Re: ******** ISSI change using AT command
Originally Posted by
harout
Ok, I'll test it, thanks.
yes. you need to send the string "AT+CNUMF=0,ISSI", where ISSI is your new ISSI
-
Junior Member
Reputation: 9
Re: ******** ISSI change using AT command
I conducted a test using the radio of MTM800 and the programming cable of COM port, and there was no response to any input commands. Is there a problem with my connection method?
-
Re: ******** ISSI change using AT command
Originally Posted by
harout
I conducted a test using the radio of MTM800 and the programming cable of COM port, and there was no response to any input commands. Is there a problem with my connection method?
It can be:
1. wrong connection parameters (speed, parity etc, by default it is 9600 bps, 8N1)
2. Wrong wiring, should be TX -> RX, RX -> TX. Just try to swap pairs
3. Wrong PEI interface speed in codeplug
Bookmarks